Vulcan-Hart ML-135309-924RX Bedienungsanleitung

INSTALLATION & OPERATION MANUAL 900RX Heavy Duty Gas Griddles MM92 M93 M94 M96 M97 MwODEL LS 4RX L-135309-924RX 6RX L-135310-936RX

- 10 - CLEANING THE GRIDDLE Empty the grease drawer as needed throughout the day and regularly clean at least once daily. Clean the griddle regularl

ADJUSTMENTS CALIBRATION 1. Each thermostat controls a 12” zone of the griddle. Using a Surface Probe temperature measurement device, observe the temp

LEVELING The griddle must be level (side-to-side and front-to-back) during operation to ensure proper performance. Improper leveling can result in une

SERVICE AND PARTS INFORMATION Contact the Service Agency in your area to obtain service and parts information. For a complete listing of Service and

- 14 - TROUBLESHOOTING PROBLEM POSSIBLE CAUSES Heat does not come on when the thermostat is turned on 1. Problem with thermostat. (Call for service

IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GAS EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START-

- 3 - INSTALLATION, OPERATION AND CARE OF HEAVY DUTY GAS GRIDDLES GENERAL Heavy Duty Gas Griddles are produced with quality workmanship and materia

This griddle is Design Certified for installation on a non-combustible counter with 4” legs, or combustible floor with 25” high stand. INSTALLATION CL

Casters are only supplied on a griddle stand. If the griddle is moved for any reason the griddle should be re-leveled (see LEVELING in this manual). F

the griddle (Fig. 1) and the regulator is positioned with the vent plug and adjustment screw upright (Fig. 2). Fig. 1 Fig. 2 The supply pressure (up

- 7 - SEASONING THE GRIDDLE Season the griddle to avoid possible surface corrosion before first use, and after every cleaning. Heat griddle to a low

900RX PILOT LIGHTING PROCEDURE 1. Turn all thermostats to the OFF position. Wait 5 minutes to allow any gas that may have accumu

USING THE GRIDDLE To preheat, turn the burners on about 20-25 minutes before cooking. A uniform and systematic approach to loading the