Vulcan-hart SG4D ML-114875 Bedienungsanleitung PDF herunterladen (Seite 6)

— 6 —

ASSEMBLING STACKED OVENS

Unpack the ovens and stack kit. Position the oven to be used as the bottom

oven on its back for access to the oven bottom, taking care not to scratch

or damage it. The gas pipe protrudes beyond the back; provide for this

when the oven is tipped back by resting it on suitable spacers (2 x 4's [51

x 102 mm], etc.). Attach the four leg assemblies with the 24 bolts and

lockwashers (6 per leg).

Place the lower oven (with legs/casters)

on the floor and remove two

/16" (11 mm)

diameter knockouts on each side of the top

cover. Remove vent guard and discard it.

Move the oven (with legs/casters) to the

installed position and place upper oven on

top of lower oven using the locating studs.

Remove the rear panel from the TOP oven.

Install the two-piece stacking common flue

(Fig. 3) with the four screws provided.

Replace the top oven rear panel.

Connect the piping between the top oven

and bottom oven. Pipe compound must be

suitable for the type of gas being used

(natural or propane).

Fig. 3

VENT GUARD

TWO PIECE

STACKING

COMMON FLUE

PL-52884

Assembling the Legs to the Oven

The legs must be installed on the bottom of the oven. Position oven on its back, taking care not to

scratch or damage it. The gas pipe connection protrudes beyond the back; provide for this when the

oven is tipped back by resting it on suitable spacers (2 x 4's [51 x 102 mm], etc.).

Attach each of the four leg assemblies to the bottom of the oven with the 24 bolts and lockwashers (6

per leg). Carefully raise the oven to its normal position.

Assembling the Stand to the Oven

Attach each of the four leg assemblies to the bottom of the oven with the

24 bolts and lockwashers

(6 per leg). Carefully raise the oven to its normal position.

Attach the undershelf to the legs with 8 bolts and lockwashers (2 per leg).

Install the rack guides into the shelf at desired locations (for pan or flat

rack), then attach the rack supports to the top end of the rack guides.

Attach rack supports to the leg assembly by removing one middle bolt and

reattaching back through the end holes in the rack support. (Fig. 2)

Fig. 2

BACK

FRONT

PL-52821

1 2 3 4 5 6 7 8 9 10 11 ... 51 52

Kommentare zu diesen Handbüchern

Keine Kommentare

Vulcan-hart SG4D ML-114875 Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Konvektionsöfen Vulcan-hart SG4D ML-114875