Vulcan-Hart MEF24A Anleitung zur Fehlerbehebung PDF herunterladen (Seite 8)

— 8 —

6. Again, lift the element handle while pulling the black handle until the elements lock themselves at

the high (cleaning) position. Both the lifting out and lowering of elements can be done in one swing,

without stopping at the intermediate (drain) position.

7. Remove the crumb tray.

8. Firmly grasp both handles of the fry tank and lift it out.

9. Strain the frying compound into a clean container.

10. Replace the empty fry tank and lower the elements to rest inside the tank.

11. Add water to the FULL mark on the tank.

12. Add any good grade of cleaner. Follow the cleaner manufacturer's instructions.

13. Turn the thermostat to 250°F and bring the solution to a boil. Boil long enough to loosen or dissolve

all "varnish" or "carbon" deposits (approximately 30 minutes).

14. Turn fryer OFF. Lift the elements to the drain position.

15. If necessary, clean the thermostat bulbs, using a long handled fiber or plastic brush and mild soap

solution.

16. Rinse with clean water to remove all cleaning mixture.

17. Lift out the fry tank and drain. Wash fry tank again with a mild soap solution. Rinse with clean water

to remove all cleaning mixture. The fry tank must be thoroughly rinsed; even a trace of cleaner

left inside the tank will ruin frying compound.

18. Rinse inside of tank with 2 cups of vinegar. Rinse with clean water until vinegar odor is gone.

19. Dry thoroughly. Replace the empty fry tank and lower the elements.

20. Cover tank until ready for further use.

Fingerprints

Fingerprints are sometimes a problem on highly polished surfaces of stainless steel. They can be

minimized by applying a cleaner that will leave a thin, oily or waxy film. Wipe cleaner on and remove

excess with a soft dry cloth. After using, subsequent fingerprints will usually disappear when wiped

lightly with a soft cloth containing a little of the cleaner. If the surface is especially dirty to start with,

wash first with soap or detergent and water.

Burned On Foods and Grease

Soaking with hot soapy water will help greatly to remove burned on foods and grease. Stubborn

deposits can be removed with scouring powder mixed into a paste and applied with stainless steel wool

or sponges.

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Vulcan-Hart MEF24A Anleitung zur Fehlerbehebung Seite 8