Vulcan-Hart VW3S ML-126504 Betriebsanleitung PDF herunterladen (Seite 6)

VW, VSL & VCW SERIES F-31086 (02-15)

5

ELECTRICAL REQUIREMENTS

ELECTRICAL CODES & STANDARDS:

The warmer must be installed in

accordance with:

In the United States of America:

1. State and Local Codes.

2. National Electrical Code, ANSI/

NFPA-70 (latest edition.) Copies

may be obtained from: The

National Fire Protection

Association, Batterymarch Park,

Quincy, MA 02269.

In Canada:

1. Local Codes.

2. Canadian Electrical Code, CSA

C22.1 (latest edition.) Copies

may be obtained from: The

Canadian Standard Association,

178 Rexcale Blvd., Etobicoke,

Ontario, Canada M9W 1R3.

ELECTRICAL CONNECTIONS:

The warmer is factory wired for either

110/120 volt or 208/240 volt, single

phase operation. All 110/120 volt

warmers are equipped with a 8 foot cord

and NEMA 5-15 plug as standard

equipment. All 208/240 volt warmers

are equipped with a 8 foot cord and

NEMA 6-15 plug. Refer to wiring

diagrams in the back of this manual.

The cord and plug supplied is a suitable

durable cord with a molded three-prong

plug, and is provided with a proper

strain relief.

: All warmers are

equipped with a three-prong plug. It

is imperative that this plug must be

connected into a properly grounded

three-prong receptacle. If the

receptacle is not the proper

grounding type, contact an

electrician. Do not remove the

grounding prong from this plug.

Verify that the power source

matches the Serial Data Plate located

on the lower back corner of the

warmer and the plug configuration

before the connection is made. (Fig. 1)

SERIAL DATA PLATE

Fig. 1

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare