Vulcan-Hart GCO2D Spezifikationen PDF herunterladen (Seite 7)

— 7 —

Fig. 3 Fig. 4

REAR OF TOP OVEN

KNOCK OUT WELDED PLATE

FOR FLUE EXTENSION INSTALLATION

BOTTOM

LOCATING STUDS

PL-52992

FRONT OF TOP OVEN

Remove the two

⁄16" (11.1mm) knockouts on each side of the top cover and place oven in upright position at

installation location. Turn the adjustable feet in or out to level the oven front-to-back and side-to-side (see

LEVELING on page 6).

Remove right-hand side panels from both ovens. Remove welded plate from bottom of upper oven (Fig. 3).

Install the two locating studs (included in the leg stack set) into screw plates on underside of upper oven (Fig. 3).

Place upper oven on top of lower oven using the locating studs.

Remove flue extension from upper oven. Install long flue extension into existing right-angled flue extension in

lower oven. Attach long flue extension to wall of upper oven using screws provided. Secure chimney to roof of

upper oven (Fig. 4).

Install right side panels on both ovens. Connect the piping between the top oven and bottom oven. Pipe

compound must be suitable for the type of gas being used (natural or propane).

The manual gas valve at the bottom of the control panel should remain off until all electrical connections are made

and the ovens are checked or used.

RIGHT ANGLED

FLUE EXTENSION

LONG FLUE

EXTENSION

CHIMNEY

PL-52221

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Keine Kommentare

Vulcan-Hart GCO2D Spezifikationen Seite 7